The X2D picks up where the X1-Carbon left off. A second nozzle takes over the messy support work, an actively heated chamber opens the door to engineering filaments, and a closed-loop servo extruder keeps surfaces clean even at full speed. This Combo package ships with AMS 2 Pro, so multi-colour printing and filament drying are ready out of the box.
Because the auxiliary nozzle can run a dedicated support material, steep overhangs, internal channels and fabric-like folds can be fully supported and then separated without gouging the model surface.
Rigid and flexible can share one print. Combine PLA with TPU for grips, bumpers and bags that come off the plate ready to use — and switch colours in a fraction of a second with far less purge waste.
A gear-and-trigger mechanism inside the toolhead swaps nozzles with a tap of the lever — no tools needed. Keeping the mechanism light also means less inertia and less ringing at high speed.
Cool air is drawn in from both the left and right sides and pushed through the chamber, so freshly extruded PLA and other low-temperature filaments set at the right moment. Overhangs stay defined and bridges stay flat.
A 300 °C nozzle handles most engineering filaments, but the actively heated chamber is what makes layers bond consistently from edge to edge across a big plate.
Flow Dynamics Calibration models the whole extrusion system rather than relying on a single fixed factor, compensating for nozzle wear, residue and slightly damp filament so results repeat.
Feeding, printing, thermal behaviour and machine safety are all monitored in real time, including door state, filament run-out, filament tangle and power-loss recovery.
Three-stage filtration — a G3 pre-filter, an H12 HEPA element and coconut-shell activated carbon — reduces odour and airborne particles. The X2D is UL 2904 certified for indoor air quality with Bambu PLA Basic and PETG Basic, and typically runs under 50 dB.
The Combo adds AMS 2 Pro: four-slot automatic material handling with vented filament drying and a faster PMSM feed motor. Expand later to as many as four AMS 2 Pro plus eight AMS HT units.
256 × 256 × 260 mm³ when printing with the main nozzle, and 235.5 × 256 × 256 mm³ in auxiliary-nozzle or dual-nozzle mode.
The X2D adds a dual-nozzle system, an actively heated chamber up to 65 °C, a closed-loop PMSM servo extruder with real-time flow sensing, filament tangle detection and a second camera on the toolhead for wider AI monitoring.
The X2D printer, AMS 2 Pro, a Textured PEI build plate, the external exhaust fan bundle, an accessory box and a spool holder.
Up to 25 colours when both hotends are combined with a maximum AMS configuration. A single hotend supports up to four AMS 2 Pro plus eight AMS HT units — 12 units and 24 slots in total.
Yes. The 300 °C hardened-steel hotend and the 65 °C actively heated chamber cover ABS, ASA, PA, PC, PET and carbon- or glass-fibre reinforced grades. Fibre-filled filaments are best run through the main nozzle.
The auxiliary nozzle can run a dedicated support material, so supports separate cleanly from the model. It also allows two materials — such as PLA and TPU — in one part and much faster colour changes with less purge waste.
All current Bambu Lab 256 mm × 256 mm plates, including Textured PEI, Smooth PEI, Cool Plate SuperTack and the Engineering Plate. First-generation plates are not auto-detected.
Yes. Three-stage filtration (G3 pre-filter, H12 HEPA and coconut-shell activated carbon) reduces odour and particles, noise typically stays under 50 dB, and the printer is UL 2904 certified for indoor air quality with Bambu PLA Basic and PETG Basic.
