Zortrax Perforated Plate V2 for M300 / M300 Plus is the V2 perforated build plate for the Zortrax M300 and M300 Plus 3D printers. It mounts on the heated bed and is the surface your parts are printed on.
This version has a conductive coating that gives the printer more spots to measure during platform calibration. The M300 and M300 Plus level the platform by measuring the height of points on it, so more measuring spots make levelling easier.
Use it to replace a worn or damaged plate. A flat, intact surface keeps large prints stuck down for the whole job. Both printers have a 300 × 300 × 300 mm build volume.
Run platform calibration after fitting a new plate. If you are not sure which plate your printer uses, message our team before you order.
