ASA · 1.75 mm · 800 g · 4 colours
Zortrax Z-ASA Pro Filament — ASA filament, 1.75 mm on 800 g spools in 4 colours (Red, Yellow, Blue, Graphite).
ASA behaves much like ABS but resists sunlight and UV far better, so colours hold up outdoors. The usual choice for parts that live outside — exterior fittings and signage.
ASA wants an enclosure like ABS, and the room should be ventilated while it prints.
Any FDM printer that takes 1.75 mm filament, which is the standard size on most machines. The right nozzle and bed temperatures depend on your printer — start from the figures Zortrax prints on the spool and adjust in 5 °C steps until surface finish and layer adhesion are both good.
Dark colours hide layer lines best, so parts look finished without sanding. White and pale shades are the better base for painting. Saturated colours separate one batch from another or make a part easy to spot. If one build needs several spools, order them together — shade can shift slightly between production batches.
Order online for nationwide delivery, or collect at True Digital Park, Seacon Bangkae or Central Sriracha. If you would rather not print it yourself, send us the file and our 3D printing service will run it for you.
The Zortrax Z-ASA Pro Filament costs ฿2,500 including VAT at Print My Design. It is in stock; stock at each branch is shown on this page.
4 colours: Red, Yellow, Blue, Graphite.
Any FDM printer that takes 1.75 mm filament.
It depends on your printer and speed. Start from the figures Zortrax prints on the spool and adjust in 5 °C steps until surface finish and layer adhesion are both good.
ASA wants an enclosure like ABS, and the room should be ventilated while it prints.
Yes, at True Digital Park, Seacon Bangkae or Central Sriracha, or we deliver nationwide.
ASA is the sun-proof version of ABS: it does not yellow or turn brittle under UV, with similar heat and impact resistance, which makes it the standard material for outdoor parts.
| Nozzle temperature | 240–260 °C |
|---|---|
| Bed temperature | 90–110 °C |
| Enclosure | Strongly recommended |
| Drying | 70–80 °C for 2–4 h if stored long |
Typical ranges for this material; the spool label and the printer profile are the authority.
Good for outdoor fixtures, sensor housings, camera and solar mounts, signage and vehicle parts that sit in the sun.
Best on an enclosed printer such as the Bambu Lab P2S, X2D or H2 series to limit warping and fumes
Needs the same enclosure and ventilation as ABS. Keep it dry and slow down a little on large parts to limit shrinkage.
