Anycubic ACE For Kobra S1

Anycubic ACE For Kobra S1 is the Kobra S1 version of the ACE Pro (Anycubic Color Engine Pro), a four-spool feeder and filament dryer that works alongside the Anycubic Kobra S1. It lets the printer switch between four filaments on its own and keeps them dry while it prints.

Highlights

• 4 colours per unit; 8 colours with two ACE Pro units and the 8-colour feeding module
• Dries filament while printing, up to 55°C, for as long as 24 hours
• Reads material and colour automatically from Anycubic filament with an identification chip; other filament works with manual setup
• Switches to a backup spool of the same material and colour when one runs out, and detects tangled filament

Key specs

• Printable filaments: PLA, PETG, ABS, ASA, PET, PA, PC, PP (1.75 mm)
• Power rating 230 W; unit weight 4.6 kg
• Standard 1 kg plastic spools, 195–200 mm outer diameter, 60–68 mm wide

Before you buy

The ACE Pro is controlled by the printer, so it cannot run as a stand-alone dryer. TPU cannot be fed through it, and fibre-filled, very hard or brittle filaments wear its feed channels. Each ACE Pro version is matched to a printer model; this one is for the Kobra S1, so check your printer before ordering or ask our team by chat.