Anycubic Wash&Cure 3 Plus

Anycubic Wash&Cure 3 Plus is Anycubic's large post-processing station for LCD resin printers with screens up to 10.6 inches. Washing off uncured resin and final UV curing both happen in one unit.

What it does

After a print, lower the build plate with the parts into the basket in the IPA bucket. The machine stirs the solvent to strip resin, then the parts go onto the two-level turntable for UV curing.

Why the 3 Plus

• 12 L bucket with a 7.6 L basket, sized for 10-inch-class printers
• Basket height of 150 mm or 250 mm for 7.6–10.6 inch build plates
• Main light of 10 × 405 nm LEDs plus a gooseneck light for fine details
• Sealed structure and tuned software keep it quieter

In the box (per the official store)

• Main unit, washing bucket, washing basket and curing table
• Gooseneck light, rack bar and hex key set
• Power adapter and instruction manual

Good to know

Use IPA above 95% concentration. Keep the anti-UV cover on while curing; the machine will not run with it removed.