Anycubic Wash&Cure Max

Anycubic Wash&Cure Max is a large automatic washing and curing machine for resin prints. It holds 14.9 litres, washes parts up to 300 × 165 × 300 mm, and suits consumer resin printers up to 13.6 inches (35 cm).

Highlights

• Two wash modes: pressurised spray rinsing for surface resin and bottom dip rinsing for fine details
• Washes parts on build plates up to 12 inches, weighing no more than 2.2 kg
• IPA-efficient: Anycubic says 4 L is enough for models of 10 inches and up, with under 50 ml lost per wash
• One button runs washing, then switches to curing automatically
• 360° rotating curing platform for all-round curing
• Alerts when the lid is not closed, water gets into the unit, or an outlet is blocked

Use and care

Close the lid fully before starting any mode, and never force it open mid-cycle. To check a part, pause first and wait for the green unlock light.

Anycubic recommends filtering or replacing the solvent after about 20 models. Clean the rotor and the strainers at the bottom of the drum regularly, and replace the container filter after more than 3 months of use.