Anycubic Wash&Cure 3 Plus is a washing and UV curing station for larger resin prints, made for LCD resin printers up to 10.6 inches. It combines an IPA wash and UV curing in one machine.
Highlights
- 7.6 L washing basket, about 13.4% more than the earlier Wash & Cure Plus, inside a 12 L bucket
- Two-level PP basket washes parts on the build plate, at 150 mm or 250 mm height, for 7.6–10.6 inch plates
- Dual-layer curing platform cures more parts per cycle
- 10 × 405 nm LEDs with lenses; Anycubic quotes 20% more even curing than the Wash & Cure Plus
- Gooseneck light adds 30,000 µW/cm² at 1–3 cm for hard-to-reach details
Specs
- Wash and cure timer 1–30 minutes; touch buttons plus rotary knob
- 36 W; 6.5 kg; 434 × 312 × 267 mm
Care
Use alcohol above 95% concentration and let parts dry before curing. If the rotor stops spinning properly, drain the solvent and clean the rotor. Anycubic suggests replacing or recycling the solvent after about 30 models.
Official Anycubic distributor in Thailand
