Fine-detail production resin · Black · 1 kg · 0.1 mm pillars · every UltraCraft Reflex
PAP10 Black is the sharp-edge production resin. It prints pillars down to 0.1 mm and raised details from 0.06 mm, with a high-gloss surface that shows no layer lines. Black is the colour people photograph unpainted, because every crease, rivet and panel line reads instantly.
UltraCraft Reflex RS, Reflex RS Turbo, Reflex, Reflex Turbo, Reflex 2, Reflex 2 Pro The Pulsing Release Module is optional — not required, but it helps with tall or delicate plates.
Genuine HeyGears material. Sold by Print My Design — authorised dealer, ships from Bangkok.
It is officially supported on UltraCraft Reflex RS, Reflex RS Turbo, Reflex, Reflex Turbo, Reflex 2, Reflex 2 Pro. The Pulsing Release Module is optional — not required, but it helps with tall or delicate plates.
Black gives the sharper result: 0.1 mm pillars, 0.06 mm raised detail and a glossy finish that photographs superbly with no paint. Ash Grey is matte and neutral, so it is easier to inspect and easier to prime and paint. Same family, different job.
Tensile strength 55 MPa, flexural strength 94 MPa, flexural modulus 2,490 MPa, elongation at break 12 % and Shore D 78, with a heat deflection temperature of 58 °C at 0.45 MPa. Dimensional tolerance is ±0.05 mm at 20 mm and ±0.08 mm at 50 mm.
Wash in 95% IPA — about 2 minutes rough wash plus 1 minute fine wash in an UltraCraft Wash at 180 r/min — then dry-cure for roughly 30 minutes in an UltraCraft Cure. Short, even curing keeps fine detail from going chalky.
Keep the bottle closed, upright, dark and dry at room temperature, and shake it well before every pour because the pigment settles. Unopened bottles keep for about 12 months from the production date on the label. Liquid resin irritates skin, so wear nitrile gloves and eye protection and work in a ventilated space. Fully cured parts are safe to handle.
